Aluminium MIG welder and panel repair system from Power-Tec

Power-Tec says this aluminium MIG and panel-repair system (part number 92545) is a fully-featured work station that incorporates an aluminium MIG welder combined with the company’s aluminium repair system — all housed on a mobile trolley.

Weld on aluminium washers or pull-pins and remove the dents with the revolutionary aluminium pin puller. The versatile MIG welder can be set up for aluminium, steel or MIG brazing.

Panel replacement is reduced, so bodyshops can look forward to increased labour (and profits) within each repair job. The repair process is sped up, turn the job around more efficiently — minimises strip down and refit and no need to wait for new panels.

The kit is supplied with a 2kg roll of aluminium MIG wire, 50 Alumax special pull-pins and 50 Alumi special pull washers. These consumables are also available under the following part numbers: 92514 (Aluminium MIG wire 2kg), 92509 (50 Alumax special pull-pins) and 92153 (50 Alumi special pull washers).